Deterco Mercury Gage Products

OD Gage

ID Gage

Measure difficult groove and radius diameters as shown here.

We will custom make I.D. measurement contacts according to the detail being measured.

Many forms of I.D. meassurement applications are available according to your requirements.

OD-gage2.jpg (6124 bytes)

Gage can be modified to any form of O.D. measurement applications - groove, radius, plain, etc.

Collet will accept your choice of any 3/8" or 8mm diameter indicator or transducer.
Custom grind special anvil forms on request.
Perfect for any S.P.C. application.
Full 1" adjustable range on frames.
.120 travel on dial actuator.
Generates from 5% to 8% on gage R&R studies.
Gage can be modified to perform I.D. measurements.
Frame sizes available from 1" to 20"
Worn gages can be restored to new condition for 50% of original cost.
Attribute type snap gaging available in same size ranges.
Carbide anvils quoted on request.

The holders are cast 356 aluminum, and heat treated to a T-6 condition. The Coefficient Thermal Expansion is, 68° - 212° F .0000119. What this means is although the holders are light, they are stable as well.

Both the Variable and Attribute Gages have a total adjusment range of one full inch, up to the 12 inch size. At that point the adjustment ranges move up to a full two inches, (i.e. 12" - 14"; 16" - 18"; 18" - 20").

The gage head on the Variable Gage has .100+ of travel.

The Vaaraiaable Gage also has a .312 wide anvil for a more solid feel.

The Indicator or Transducer Collet has also been extended to allow a better hold without increasing the pressure. This also allows the customer to utilize some of the newest extended length indicators without difficulty.

The face clearance has been increased to enhance the gages ability to get into place where the anvils need to be flush with the part. This allows this to be done, in most cases, without interference.

As always, the indicator can be positioned in a 360° rotation.