|
METAL
DISINTEGRATORS.
Much
more than a tap and drill remover.
 |
Cut
hexagon shapes
for Allen wrenches to remove broken studs or bolts.
Remove frozen studs
by cutting two cylindrical holes as shown. Insert a pin in each
hole and turn out the stud. Or cut a series of holes across the
diameter and cut the stud in half.
PLUS:
Emboss identification on steel rolls
Drill and counterbore hardened steel
Re-center hardened shafts
Cut internal crossholes in hard material
Cut starter holes in hardened die steels for wire EDM
Cut ejector pin holes in die steel
Cut dovetails in hardened die steel |
A
clean cut with no damage to the workpiece.
 |
Because
the high temperature arc between the electrode, the workpiece
is continuously quenched by the pressure coolant, there is no
annealing of material around the hole. The hole created by the
arc takes the same shape as the electrode used.
Use any conductive material
Any tubing material that conducts an electrical current can be
used as an electrode. However, ELECTRO ARC molybdenum electrodes
are recommended because their high melting point, low erosion,
and high conductivity deliver maximum performance.
|
| |
BENEFITS
to you:
Reclaim expensive parts quickly, easily
Reduce labor costjobs finished in seconds instead of hours
No waiting for parts to be returned from outside sources
Portable, flexible, and affordable
Immediate repairs on works of all types
Eliminate production overruns and late deliveries
Scrap reclamation |
|
