Chamfer gauges

Internal taper gauges measure directly and exactly the major diameter of internal tapers or tapered slots. Examples for application: Measuring of the major diameter of rivet seats, centre bores, cone holes etc. as well as the chamfering of slots. The size can be read directly on the special dial indicator.

Technical data:

• Operative range: Internal taper Ø 0,5 mm to Ø 127 mm
• Taper gauge angle: 60° / 90° / 127°
• Graduation of the dial gauge 0,01 mm
• Measuring range: 19,5 mm (60°-gauge 11,5 mm)
• Taper gauge made of hardened steel
• Special design on request
• Calibration: zero-set at the factory or via setting master
  

External taper gauges:

The measuring principle is comparable with the internal taper gauge. Instead of a taper gauge it is checked by a tapered inner cone. The minor diameter of a chamfered shaft is measured.

Technical data:

• Operative range: External taper Ø 0,5 mm to Ø 127 mm
• Inner cone angle: 60° / 90° / 127°
• Dial graduation of the dial gauge 0,01 mm
• Measuring range: 19,5 mm (60°-gauge 11,5 mm)
• Inner cone made of hardened steel
• Special design on request
• Calibration: zero-set at the factory or via setting master

Chamfer gauges are used for measuring of 45° chamfers on rectangular or cylindrical work-pieces. The size of a 45° chamfer is directly indicated on the special dial gauge. Chamfers with other angles or radii can be determined by a comparison measurement or by conversion.

Technical data:

• Types: KT for rectangular work-pieces (slots from slot width 16 mm)
• KT-B for cylindrical work-pieces (bores > Ø 28 mm)
• Measuring range: Chamfers from 0 to 7 mm
• Radii from 1 to 9,5 mm
• Calibration by setting master
• Special design on request